FERNLEY, NV
Maintenance tech handling and help with new winders. All must have steel toes/long pants not sweats or shorts and short sleeve shirts not tank tops. Some experience be willing to learn but of course the more experienced the better
Reassembling machines after the completion of repair or maintenance
• Start machines and observe mechanical operation to determine efficiency and to detect
• Inspect or test damaged machine parts and mark defective areas or advise supervisors of
• Lubricate or apply adhesives or other materials to machines, machine parts, or other equipment
according to specific procedures.
• Install, replace, or change machine parts and attachments according to production
• Dismantle machines and remove parts for repair using hand tools, chain falls, jacks, cranes, or
• Record production, repair, and machine maintenance
• Read work orders and specifications to determine machines and equipment requiring repair or
• Set up and operate machines and adjust controls to regulate
• Transport machine parts, tools, equipment, and other material between work areas and storage,
using cranes, hoists, or dollies.
• Collect and discard worn machine parts and other refuse in order to maintain machinery and work
• Clean machines and machine parts, using cleaning solvents, cloths, air guns, hoses, vacuums, or
other equipment.
• Performing ongoing preventative maintenance on facility
• Repair or replace control devices such as switches, photo eyes, proximity sensors, push buttons,
contactors, motor starters, etc. as needed.
• Comply and participate in regulatory, Carlisle, And departmental policies, procedures, and
standards (PSM, safety protocols, COS)
• Articulate to vendors/engineer’s machine issue to resolve technical
• Assist with basic electronics/ Programmable Logic Control